Wallpaper is the most common decoration material for wall decoration. When interior decoration is done, many people will choose wallpapers with rich colors and good quality. If the wallpaper does not adhere well, the effect of wallpaper will be affected. It is very important, then what are the wallpapering steps ? Next Xiaobian will take everyone to know about the wallpapering steps . Wallpaper step 1. Whether the wall surface is smooth or not will affect the paste effect of the wallpaper. We can get rid of the original paint, wallpaper, and other objects on the wall. If there are cracks or potholes on the wall, you need to use plaster to fill it. After the formation, bandages are applied. If the wall is a sand-lime wall or a partition wall, we have to paste it. If the owner is not satisfied with the quality of the wall, we can choose to plaster the wall with plasterboard. 2, after the formation of the wall, we must also brush the base film, putty. When we brush the base film, we must make it uniform and have a moderate thickness. The putty must be applied twice. After the wall putty is allowed to dry, we can choose to sand the wall surface to make the wall smooth. Finally brush again and again to brush the base film evenly. The last time the base film does not need to be too thick. 3. Before wallpapering, we must first know the area of ​​the wallpaper we need to paste. We can use a tape measure to measure the size of the wall and record it. 4, the general standard wallpaper length is 10 meters, a width of 0.52 meters, we follow the measured wall height before cutting wallpaper, in the cutting time to more wall height of about 10cm, for the flower wallpaper we also consider the pattern Symmetry, after the planning is good to cut, after the wallpaper is cut, but also do a good job of numbering, generally cut a good wallpaper need to soak in clean water for about 10 minutes. 5, after the wallpaper is soaked, we can evenly brush the glue on the back of the wallpaper and the wall surface. During the brushing process, we can not wrap the edges and start stacking. When brushing the walls, the width of the brushing is 30 millimeters wider than the width of the wallpaper. After the wallpaper has been painted, place the glue on the face and fold it for 5 minutes. 6, in the paste wallpaper, we must adhere to the first vertical after the first, after the first, the first high after the low principle, when we paste the first wallpaper, we must first find a baseline in the corner, hand gently The wallpaper is flattened from the top to the bottom and from the center to the sides. Finally, a scraper is used to scrape on the wallpaper. If the glue is exposed on the wallpaper, wipe it with a wet towel. When the second wallpaper is pasted, it should have a good pattern with the previous one, overlapping about 20 millimeters at the junction, and then we will divide the overlapped part and finally scrape with a scraper. If there is a switch on the wall, we need to mark the position of the cross switch on the wall of the power switch, and use the scraper and cutting knife to cut out the excess. Xiao Bian concludes: We have introduced this article on the wallpapering procedure Xiaobian. I hope that after reading this article, I can provide you with reference and help. Wallpaper step Light Powder-actuated Fastening Tool is low velocity powder actuated, single shot, .22 caliber tool which is designed for light base and concrete not harder than C40. Light Powder-Actuated Fastening Tool Light Powder-Actuated Fastening Tool ,Direct Fastening,Powder Tool,Powder Actuated Tools Yibin Heheng Technology Co.,Ltd , https://www.actuated.nl
