The installation of the cycloid reducer is divided into the following steps:
1. Rotate one of the cycloidal wheels by 180°. When the middle bearing hole and the ten hole completely coincide, the outer tooth type is just misaligned. The upper heel position is just the top position of the next part. Then, it is necessary to pay attention now, the relative position of these two wheels must be kept in mind, it is best to use the pen to mark.
2. Place a cycloidal wheel into the pin housing and try to rotate to determine if it is smooth and swinging.
3. At this time, the eccentric bearing is placed. Because the bearing hole of the cycloidal wheel is equivalent to the outer casing of the eccentric bearing, the correct position of the eccentric bearing is that the bearing hole of the lower cycloidal wheel just bends the cylindrical ball containing the eccentric bearing.
4, can be placed in the spacer ring, it looks like an iron ring smaller than the cycloidal wheel.
5, then put another twisting wheel, this is the key step of installing the cycloid reducer, you must put the side of the cycloid with the steel print and the side of the cycloid with the steel face up. And the stencils of the upper and lower cycloidal wheels must be offset by 180°, and in a straight line, instead of the words of the upper and lower two cycloidal wheels.

6. Finally, put the bushing in the hole of the cycloidal wheel, and turn it by hand to see if it can be rotated to check if it is installed correctly. If you can rotate it smoothly, you can mount the stand. At this point, a cycloidal pinwheel reducer has been installed.

This article is from: http://