In order to make a dryer equipment work properly, it is impossible to lack the parts inside. The parts of the dryer are many. Today we will introduce to you that few of them know the hammers of the parts. The hammer of the dryer can effectively cut large pieces of material, thereby increasing the output and efficiency of the dryer. **
The thickness of the hammer of the dryer produced by the regular dryer manufacturer is usually about 5-7 mm. This is because the hammer has the function of cutting when it is hit by the material, which can effectively reduce the consumption of hot air and improve the production efficiency. . If the hammer of the dryer is too thick, the material cannot be cut efficiently, resulting in waste of hot air. Too thin will be corroded by the hot air inside the dryer cylinder, and the direct damage will seriously affect the drying speed of the dryer. At the same time, the end line speed of the dryer hammer will also affect the drying efficiency of the dryer, because the principle of the dryer hammer and the principle of the crusher are basically the same. The linear speed of the hammer of the dryer must be strictly controlled within a certain condition. Although the linear speed of the hammer of the dryer is conducive to the cutting of the material, the excessive linear speed will cause the material to rotate with the hammer. Affect the discharge, the output will naturally not be high
When purchasing the dryer equipment, you must choose a professional dryer manufacturer, so as to ensure that the purchased equipment will not have problems during the work, thus affecting normal production activities.
Dryer price : http://