Botou pressure tile machinery factory teach you floor board machine debugging method

In the process of commissioning the Botou head pressure tile machine factory floor boarding machine, the first row and the last row of the floor bearing board machine must first find a good center.

The floor bearing machine has a middle wheel that needs to pull a straight line before and after the center of the middle wheel, and then adjust the gap between the upper and lower shafts to make the performance of the automation system more superior. It is possible to adjust the machine along a straight line. Then the billet feeder and the wattage conveyor line and other components make up the billet production line. Before this type of equipment appears, it needs to be completed manually. Now, the emergence of this equipment requires no manual operation, and can be completed automatically. .

It is equipped with a lubrication system. During the operation of the machine, lubrication of the parts of the transmission gear mechanism, such as the guide rail, is performed. After the sludge blank is fully vented, the upper mold presses the blank in place again until it returns to the highest position, so the mold has a long service life and the quality of the pressed product is good. When the tile machine is in operation, shovels or other objects must not be inserted into the mixer.

The four rows of four corners of the floor bearing machine have the same amount of height from the top of the shaft to the top of the shaft. Then from the first row to the last row, one needs to find a straight line to ensure that they are on a horizontal line. And need to check, automatically for all bearing bearings, greatly save the space, the time to replace the two plates has become shorter, the entire unit automation control system uses a highly integrated network. Then tighten the two sides to lock the mother, the cost is low to become the mainstream process, the lower axis is in a straight line, the left and right sides of the lower shaft is adjusted to level. The output rate is also increased, but at the same time, it is difficult to install and adjust the molding condition because it is relatively crowded.